Do mice eat spray foam? Why the gap matters more than the insulation
Before a winter insulation job, a Somerville builder sorts what the evidence says about mice and foam, cellulose and fiberglass, and what to seal first.

You are about to have the attic or walls insulated, and you have heard mice in the house. Now you wonder whether mice will chew the new insulation, whether foam is safer than fiberglass, or whether you will seal them in. I get this question every fall in Somerville and Cambridge.
Here is what I could verify, what I couldn't, and the order of work I'd follow before any insulation crew arrives. I won't repeat the nine entry points from my mice-in-the-walls guide. This post is about timing and what to do with the insulation itself.
Will mice chew my insulation?
Short answer: assume they can, whatever the material. I looked for a university, EPA or building-science test, because most of what you find online is from insulation and pest-control companies with something to sell. Here is what I found:
- A lab test. University of Nebraska researcher Scott Hygnstrom put house mice in 20 insulated panels with unlimited food and water for six months. Mice damaged every material tested: insulation board, fiberglass batt, rockwool, beadboard and vermiculite. He wrote that no insulating material had yet been found that mice can't damage. It was published in 1996, and a lab panel with free food is a worst case, not a house.
- An extension guide. The Nebraska rodent-proofing guide (2003, revised 2009) says rodent damage to insulation raises heating and cooling bills, and that damage raises heating and cooling bills.
- EPA. An EPA Indoor airPLUS bulletin on pest entry (June 2019) says rodents can chew through spray foam, wood and some plastics.
What I could not find: any university or government test of cellulose or spray foam against mice. Trade sites claim closed-cell foam is tougher, or that borate-treated cellulose deters pests, or the opposite. Those claims conflict and I couldn't verify them. So I treat the evidence as mixed.
Fiberglass, cellulose or foam: what I'd say about each
| Material | What I could verify | What I'd do |
|---|---|---|
| Fiberglass batts or blown fiberglass | Batts were damaged in the Nebraska lab test. No extension test of blown fiberglass found. | Seal gaps first. Pull and replace any batts that mice have nested in. |
| Mineral wool | Rockwool was damaged in the same lab test. | Same as above. |
| Cellulose, loose or dense-pack | No university or government test found. Vendor claims go both ways. | Dense-pack leaves fewer open voids, which I like, but I can't point to a study showing mice stay out. See dense-pack cellulose in old walls. |
| Spray foam, open or closed cell | EPA says rodents can chew it. Nebraska warns sunlight breaks foam down. | Put metal behind the foam at gaps. Cover foam that sunlight can reach. See insulation types compared. |
| Rigid foam board | Board was damaged in the lab test. Nebraska says foam on the outside of a foundation needs a hard covering that runs 36 inches below grade. | Protect it with cement board or stucco where it is exposed. |
None of this means skip insulation. Insulate for comfort and heating bills, and choose the material for that. Just don't expect it to be the barrier.
Why does the gap matter more than the material?
Insulation is not what makes mice come in. Warmth, food and a hole they can fit through do that. The Nebraska guide says a mouse can enter through a gap just over 1/4 inch, about the width of a pencil. Once inside, the insulation is a soft place to nest and tunnel.
That's why my advice is the same for all five materials. Close the opening with something they can't chew, then insulate. The Nebraska guide also warns that rodents will return through any opening that stays unsecured after a control program. A mouse that can't get in doesn't care what's in your attic.
Weatherization helps here. Air sealing closes many of the same gaps that let heat out, and EPA's bulletin says air sealing helps keep rodents outside. But air sealing foam and caulk are not gnaw-proof, so the metal comes first.
Where do I seal before the insulation goes in?
Start with the places air and mice both use. In an old house that's the rim joist and sill, utility penetrations, and the attic floor.
- Rim joist and sill. The slot where the wood sill meets an uneven stone or brick foundation is a common gap. Pack copper or stainless mesh into it, or have a mason fill it, then air seal over that.
- Pipes, wires and vent penetrations. EPA says to seal holes bigger than 1/4 by 1/4 inch with corrosion-resistant copper or stainless wire mesh. It also says to seal cracks around plumbing and wiring penetrations and cover the seal with escutcheons or metal flashing.
- Attic floor. Holes where wires, pipes and chimney chases pass up through the ceiling let both air and mice in. These should be sealed before blown insulation covers them and hides them.
- Roofline. Hardware cloth behind soffit and gable vents, the mesh sizes in my earlier guide.
EPA adds a good detail: don't leave a rough surface that triggers rodents' instinct to chew. Finish the repair smooth and neat, and keep wood dry, since EPA notes wet wood is easier for animals to gnaw.
Three safety limits. Never seal a boiler or water heater flue, combustion air opening or dryer duct. Gaps around a chimney, flue or recessed light follow fire clearance rules, so those need a pro. Gas and electric lines are for a licensed plumber or electrician. If the house has live knob-and-tube wiring, insulation has to wait; see my attic wiring and vermiculite guide.
What order should the work go in?
Seal in the wrong order and you can trap animals in a cavity that is then filled with insulation. I wouldn't close a wall or attic with something still alive in it. A dead animal in a packed wall is hard to find. Here is the order I use:
| Step | What happens | Who |
|---|---|---|
| 1. Check for activity | Droppings, rub marks, nests, a smell, night noise. Mark every gap with tape and photos. | You |
| 2. Trap what is inside | Snap traps along walls out of reach of kids and pets, or a licensed pest pro for a bigger problem. | You or a pest pro |
| 3. Seal outside and basement gaps | Mesh, sheet metal or mortar at the foundation, sill and utility holes. | You for small gaps; builder or mason for the rest |
| 4. Clean out soiled insulation | Wet methods and protective gear, covered below. | You if light; a pro if heavy |
| 5. Seal the attic floor and rim joist | Metal at gaps first, then air sealing over it. | Builder or the insulation contractor |
| 6. Insulate | The material you picked for energy reasons. | Insulation contractor |
| 7. Check again in spring | Fresh droppings, new gnawing, daylight at a gap. | You |
How do I clean out old insulation that mice used?
Do this before new insulation goes over it. New insulation on top of droppings and urine just buries the problem. The CDC's cleanup guidance (page updated April 8, 2024, read November 18, 2026) says:
- Don't sweep or vacuum droppings, urine or nesting material. That can put virus-containing droplets into the air.
- Air out the space first by opening doors and windows for about 30 minutes. Wear rubber or plastic gloves, and insect repellent on clothing and hands if you'll handle nests or dead rodents, since fleas are common. Spray droppings and urine until very wet with a bleach solution (the CDC mix is 1.5 cups of bleach per gallon of water, made fresh) or an EPA-registered disinfectant, and let them soak at least 5 minutes or as the label says.
- Wipe up with paper towels and put them in a covered trash can. Mop hard surfaces with disinfectant, then wash your hands.
- If exposed insulation is contaminated with urine and droppings, put it into plastic bags for removal. Handle potentially contaminated material outside and stay upwind so dust doesn't blow toward your face.
For a heavy infestation the CDC lists extra gear: coveralls, boots or shoe covers, gloves, goggles and a half-mask respirator with a HEPA filter or a powered air-purifying respirator, with fit testing under local rules. It also says to call a professional exterminator if rodents have reached the heating and cooling ducts. In a cramped attic with matted, stained insulation, that's where I'd stop and hire a pro. A dust mask from the hardware store is not that gear.
I couldn't find whether Mass Save pays for pest cleanup. Ask when you book. On a house built before 1978, work that disturbs painted trim or plaster while you open things up a hired contractor has to follow lead-safe rules; see what that means.
What about poison?
I'd keep it out of the house. Penn State Extension advises avoiding rodenticides inside homes: they risk children and pets, and a poisoned mouse can die in a wall or attic, where you'll smell it and may not reach it. MassWildlife's wildlife and rodenticide page advises avoiding rodenticides, especially second-generation anticoagulants, because poisoned rodents can pass the poison to owls, hawks and other wildlife, and to pets. It recommends baited snap traps as the safer first step.
Traps remove what's inside. Sealing keeps the next ones out. If the rats are in your yard too, see what the city does and what is on you.
How does this fit with Mass Save and winter weatherization?
Mass Save starts with a Home Energy Assessment. My Mass Save insulation guide (October 22, 2026) covers the offers and steps. Sealing before the assessment visit keeps it from delaying the crew.
I'm not a Mass Save installer. The insulation work is done by program-approved contractors. What I do is the work around it: sealing, repairs and getting the house ready. Rodent exclusion isn't something I saw on the program's list of offers, so budget for it separately and plan to do it before the crew arrives. For a broader look at drafts, see air sealing a drafty house and my older-home winterizing checklist. For R-value targets, see attic insulation in Massachusetts.
Want a second set of eyes before the insulation goes in?
I'm Mateus, a licensed builder in Davis Square. Since 2020 I've renovated and managed over $5 million in projects around Somerville and Greater Boston. If you're planning insulation and you know you have mice, book a free walkthrough. I'll look at the sill, penetrations and attic floor and tell you what to seal first, and who should do it.
Frequently asked questions
Do mice eat spray foam?
They can chew it. EPA's Indoor airPLUS bulletin says rodents can chew through spray foam, wood and some plastics. I found no university test of how much spray foam resists mice, and trade claims conflict. Put copper or stainless mesh or sheet metal at gaps and use foam only to finish over it.
Is any insulation mouse-proof?
I couldn't find one that is. A University of Nebraska lab test found mice damaged every insulation it tried: insulation board, fiberglass batt, rockwool, beadboard and vermiculite. Cellulose and spray foam weren't in that test. The reliable fix is sealing the gaps, not choosing a material.
Will dense-pack cellulose keep mice out of my walls?
I don't have evidence that it will. I couldn't find a university or government test of cellulose against mice, and vendor claims conflict. Dense-pack leaves fewer open voids, but sealing the sill, penetrations and roofline is what keeps mice out.
Should I remove mouse-contaminated insulation before adding more?
Yes, I would. The CDC says not to sweep or vacuum droppings, urine or nests, to wet them with disinfectant, and to bag contaminated insulation and handle it outside, upwind. For a heavy infestation it lists coveralls, goggles and a HEPA half-mask or powered respirator, so I'd hire a pro for a large attic.
Should I seal the holes or set traps first?
Trap first. If you close every opening while mice are inside, they stay in the wall or attic. Once the traps stop catching anything, seal the gaps with metal or masonry, then insulate. Check again in spring.
Is it safe to use poison before insulating?
I wouldn't. Penn State Extension advises avoiding rodenticides inside homes because of risks to children and pets and because mice die in walls. MassWildlife says poisoned rodents can also harm owls, hawks and pets, and points to snap traps as an alternative.
See everything I do, how I price work and the towns I work in.
Read this next
Home Care & SafetyMice in the walls of your old house: the 9 places they get inScratching in the walls of a Boston-area old house? Nine entry points, how a builder seals them with metal and masonry, and when a wall has to be opened.9 min read · Keep reading →
Home Care & SafetyBlown-in vs fiberglass vs spray foam: which insulation is right for your Greater Boston home?Cellulose, fiberglass, mineral wool and spray foam compared: R-value, cost and where each works best in Somerville, Cambridge and Boston homes.3 min read · Keep reading →
Home Care & SafetyDense-pack cellulose: how to insulate the walls of an old Somerville, Cambridge or Boston house without tearing them outMost Greater Boston homes built before 1940 have empty walls. How dense-pack cellulose is blown into existing walls, what it costs, and what to check first.3 min read · Keep reading →
Costs & BudgetsMass Save insulation rebates in 2026: 75–100% off, no-cost options and the steps for Somerville, Cambridge and Greater BostonMass Save insulation in 2026: how the 75–100% off and no-cost offers work, what's covered, the federal credit that ended, and the steps to get started.3 min read · Keep reading →
Home Care & SafetyKnob-and-tube, vermiculite and other attic surprises: what to fix before you insulate an older Greater Boston homeOld wiring or gray pebbles in your attic? What knob-and-tube and vermiculite mean for insulating a Somerville, Cambridge or Boston home.3 min read · Keep reading →
Home Care & SafetyHow to winterize a drafty house: an air-sealing and insulation checklist for Somerville, Cambridge and Greater BostonCold rooms and high heating bills? Find where a Greater Boston house really leaks (attic, basement, windows, outlets) and fix it before winter, step by step.3 min read · Keep reading →


























